Transferring Data between Remote Commanders (continued)
To receive the data of the Component Select button from another remote commander
5Press ENT.
The S (set) indicator lights up and the selected Component button turns off
1~2 Perform Steps 1 to 2 on page 40.
3While holding cursor V pressed, press the Component Select button to which want to set the data.
The S (set) indicator flashes, and the selected Component button lights up.
6Press ENT (ENTER) on the sending remote Commander.
After the data is received, the Component Select button lights up. If data transfer has been unsuccessful during or after the procedure, both the S (set) indicator and the Component button flash five times, and the Commander returns to its state in Step 5. Either try again from Step 6, or press S (set) to cancel data receival.
4Confirm that the sending remote commander is ready for data transfer.
(To set the sending commander, follow the procedure on page 39.)
Note
Be sure that the sending remote commander is ready to transfer data.
Note
If you do not perform Step 6 within 10 seconds, the S (set) indicator and the Component Select button flash five times, followed by a short pause, and then flash again.
42