Executing a Series of Commands
—System Control Function (continued)
If a series of commands is already programmed on that button
To program a new series of operations, clear the program first (page 28).
3Follow Steps 3 to 6 on pages 24 and 25
To execute the series of commands
Press and hold the programmed Component button for more than 2 seconds.
Notes
•You can program the System Control function on a Component Select button on which the
•You cannot program the System Control function on a Component Select button on which a signal has been programmed by the Learning function (page 15).
•You can program a signal on a Component Select button by Learning (page 15) on which the System Control function has been programmed. In this case, the System Control function is overwritten and cannot be used. If you clear the “learned” signal on the button, the System Control function is resumed and you can use it again.
•You can program the
•If you interrupt the procedure at any point for over 10 seconds, the setting mode ends and the series of commands will be programmed to that point. In this case, clear the program and start again from Step 1 to set the entire program from the beginning. You can not continue from where you let off.
•If you change the component code number (page 8) or program a new signal by Learning (page 15) on a button that has been programmed in the series of commands of the System Control function, the new signal will be transmitted when you press the corresponding Component Select button.
To clear the System Control function programmed on the Components Select buttons
Example: To clear the programmed commands on the VCR button
While holding S (set) pressed, press VCR.
The Component button lights up when you press them, and turns off when you release them.
28