HELP20

Adhesive bond (LOCTITE 460) (Note)

Note: Use adhesive bond (LOCTITE 460) or an equivalent article.

Do not use what becomes white after drying like quick-drying glue.

Apply the adhesive bond (LOCTITE 460) to the tip of mount guide mark and install it to the G ornamental block.

Apply the adhesive bond (LOCTITE 460) to the tip mount guide mark

Mount guide mark

G Ornamental Block

m ft

HELP21

Adhesive bond (LOCTITE 460) (Note)

Note: Use adhesive bond (LOCTITE 460) or an equivalent article.

Do not use what becomes white after drying like quick-drying glue.

Adhesive bond (B-10): J-6082-612-A

1.Apply a little amount of the adhesive bond (LOCTITE 460) to the indicated portions of focus hold button base.

2.Apply the adhesive bond (B-10) to the tip of one screw shown in figure and tighten the screw.

3.Perform “4-8. FOCUS HOLD BUTTON CHECK (FOCUS HOLD BUTTON)”.

Apply the adhesive bond (B-10)

Apply the adhesive bond (LOCTITE 460)

 

Washer

 

 

Focus Hold Button Base

 

Focus Hold Button

Click Plate

Dust Protection Tape

 

SAL35F14G (1.4/35G) (35mm F1.4G)

HELP

Page 30
Image 30
Sony SAL35F14G service manual HELP20, HELP21