There is severe hum or noise.

•Check that the speakers and components are connected securely.

•Check that the connecting cords are away from a transformer or motor, and at least 10 feet (3 metres) away from a TV set or fluorescent light.

•Move your audio components away from the TV.

•Make sure you have grounded the U SIGNAL GND terminal (only when a turntable is connected).

•The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.

There is no sound, or only a very low- level sound is heard from the center/ surround/surround back speakers.

•Select a Cinema Studio EX mode (page 54).

•Adjust the speaker level (page 59).

There is no sound from the subwoofer.

•Check that the subwoofer is connected correctly and securely.

•Make sure you have turned on your subwoofer.

•Depending on the selected sound field, no sound output from the subwoofer.

•When all speakers are set to “LARGE” and “Neo:6 Cinema” or “Neo:6 Music” is selected, there is no sound from the subwoofer.

The surround effect cannot be obtained.

•Make sure the sound field function is on (press MOVIE).

•Sound fields do not function for signals with a sampling frequency of more than 48 kHz.

Dolby Digital or DTS multi channel sound is not reproduced.

•Check that the DVD, etc. you are playing is recorded in Dolby Digital or DTS format.

•When connecting the DVD player, etc., to the digital input jacks of this receiver, make sure the setting for the digital audio output of the connected component is available.

Recording cannot be carried out.

•Check that the components are connected correctly.

•Select the source component using the input buttons (page 44).

The MULTI CHANNEL DECODING lamp does not light up in blue.

•Check that the playback component is connected to a digital jack and the input is selected properly on this receiver.

•Check whether the input source of the software being played back corresponds to the multi channel format.

•Check whether the setup on the playback component is set to multi channel sound.

•Check to make sure the selected digital audio input jack is not assigned to other inputs in “Input Assign” in the Input menu (page 82).

There is no sound from the component connected to the DIGITAL MEDIA PORT adapter.

•Adjust the volume of this receiver.

•The DIGITAL MEDIA PORT adapter and/or component is not connected correctly. Turn off the receiver, then reconnect the DIGITAL MEDIA PORT adapter and/or component.

•Check the DIGITAL MEDIA PORT adapter and/or component device to make sure it supports this receiver.

110US