Sony STR-DG920 Note, Tips, Item, WARN, 94US, Press, Press, RETRY, again, CHECK, result, process, When the, properly, When the, completes, E – xxx :, (page 43), SAVE EXIT

Performing Auto Calibration

For details on the Auto Calibration, see “9: Calibrating the appropriate speaker settings automatically (Auto Calibration)” (page 39). Refer to “Before you perform Auto Calibration” (page 40) before performing the Auto Calibration.

To operate on the receiver1Press GUI MODE repeatedly to select “GUI OFF”.2Press AMP.Receiver operation is enabled.3Press MENU.4Press V/v repeatedly to select “<AUTO CAL>”, then press .

5Press V/v repeatedly to select “A.CAL START”, then press to start the measurement.

Measurement starts in 5 seconds. A count down is displayed.

Note

While the time is counting down, stand away from the measurement area to avoid measurement error.

6Measurement starts.

The measurement process will take approximately 30 seconds. Wait until the measurement process completes.

To cancel Auto Calibration

The measurement will be canceled when you do the following:

–Press ?/1, input buttons or MUTING.

–Press SPEAKERS (OFF/A/B/A+B) on the receiver.

–Change the volume level.

–Connect the headphones.

Tips

•Operations other than turning the receiver on or off are deactivated during Auto Calibration.

•The measurements may not be performed correctly or Auto Calibration cannot be performed when special speakers, such as dipole speakers are used.

To confirm/save Auto Calibration when GUI function is turned off1Confirm the measurement result.

When the measurement ends, a beep sounds and the measurement result appears on the display.

Measurement Display		Explanation
result
When the	COMPLETE Proceed to step 2.
measurement
process
completes
properly
When the	E – xxx :	See “Message list
measurement	xx	after Auto
process fails		Calibration
		measurement”
		(page 43).

2Press V/v repeatedly to select the item, then press .

Item	Explanation
RETRY	Performs the Auto Calibration
	again.
SAVE EXIT	Saves the measurement results
	and exits the setting process.
WARN	Displays a warning concerning
CHECK	the measurement results. See
	“Message list after Auto
	Calibration measurement”
	(page 43).

PHASE INFO. Displays the phase of each speaker (in phase/out of phase). See “When you select “PHASE INFO.”” (page 95).

DIST. INFO. Displays the measurement result for speaker distance.

94US