SpecificationsAUDIO POWERSPECIFICATIONSPOWER OUTPUT AND TOTAL HARMONIC DISTORTION:(Models of area code U only)

With 8 ohm loads, both channels driven, from 20 – 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output.

Amplifier section

Models of area code U, CA1) Minimum RMS Output Power

(8 ohms, 20 Hz – 20 kHz, THD 0.09%) 100 W + 100 W

Stereo Mode Output Power (8 ohms, 1 kHz, THD 0.7%)

110 W + 110 W

Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%)

150 W per channel

1)Measured under the following conditions:

Area code

Power requirements

U, CA

120 V AC, 60 Hz

 

 

2)Reference power output for front, center, surround and surround back speakers. Depending on the sound field settings and the source, there may be no sound output.

Frequency response

Analog

10 Hz – 100 kHz,

 

±3 dB (with sound field

 

and equalizer bypassed)

Input

 

Analog

Sensitivity: 150 mV/

 

50 kohms

 

S/N3): 96 dB

 

(A, 20 kHz LPF)

Digital (Coaxial)

Impedance: 75 ohms

 

S/N: 100 dB

 

(A, 20 kHz LPF)

Digital (Optical)

S/N: 100 dB

 

(A, 20 kHz LPF)

Output (Analog)

 

AUDIO OUT

Voltage: 150 mV/1 kohms

SUBWOOFER

Voltage: 2 V/1 kohm

Equalizer

 

Gain levels

±10 dB, 1 dB step

3)INPUT SHORT (with sound field and equalizer bypassed).

FM tuner section

Tuning range

87.5 – 108.0 MHz

Antenna (aerial)

FM wire antenna (aerial)

Antenna (aerial) terminals

75 ohms, unbalanced

Intermediate frequency

10.7 MHz

AM tuner section

Tuning range

Models of area code U, CA

With 10-kHz tuning scale:

530– 1,710 kHz4)

With 9-kHz tuning scale:

531– 1,710 kHz4)

Antenna (aerial) Loop antenna (aerial) Intermediate frequency

450 kHz

4)You can change the AM tuning scale to 9 kHz or 10 kHz. After tuning in any AM station, turn off the receiver. While holding down TUNING MODE, press POWER. All preset stations will be erased when you change the tuning scale. To reset the scale to 10 kHz (or 9 kHz), repeat the procedure.

114US