Radio stations cannot be tuned in.

•Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary.

•Keep the XM antenna, away from the speaker cords and the power cord to avoid picking up noise.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 64).

•Press DISPLAY repeatedly so that the frequency appears on the display.The receiver cannot receive XM channels at all.

•The receiving condition is not good. Move the antenna to the place where the condition is good.

•Check that you subscribed to the satellite radio service you want (page 65).Remote commanderThe remote does not function.•Point the remote at the remote sensor on the receiver.•Remove any obstacles in the path between the remote and the receiver.•Replace all the batteries in the remote with new ones, if they are weak.•Make sure you select the correct input on the remote.

•When you operate a programmed non- Sony component, the remote may not function properly depending on the model and the maker of the component.

Error messages

If there is a malfunction, the display shows a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.

PROTECTOR

Irregular current is output to the speakers, or upper panel of the receiver is covered with something. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again.

For other messages, refer to “Message list after Auto Calibration measurement” (page 43), “XM Radio message list” (page 71) and “DIGITAL MEDIA PORT message list” (page 80).

If you are unable to remedy the problem using the troubleshooting guide

Clearing the receiver’s memory may remedy the problem (page 35). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver.

If the problem persist

Consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained.

Reference sections for clearing the receiver’s memory
To clearSee

All memorized settings

page 35

 

 

Customized sound fields

page 55

 

 

113US

Information Additional