This is the Internet version of the user’s guide. © Print only for private use.

• Backup and restore

Set the P800 in Modem mode when using

P800 as a modem

Dial-up network wizard

You should disable the USB cable connection in these three

cases. In your PC select Start > Settings > Control Panel > Phone

Monitor Options > COM Ports and disable the COM port to which the cable is connected.

Connection via infrared port

When connecting via the infrared port, make sure that both devices are placed within one meter from each other and that the infrared ports have a free line of sight between them.

Both your P800 and the device you connect to must have their infrared ports activated before communication can begin.

To activate the infrared port on the P800

Go to Control panel > Connections > Infrared port and set the port state to On or On for 10 minutes.

You can also change the infrared port state with the flip closed, in the Connections application.

To activate the infrared port on the PC

1.Right click in the status area to the right on the taskbar.

2.Select Properties

3.Select the Infrared check box

4.Click Close.

Note Clear the Infrared check box when ready.

Send and receive

You can send objects via the infrared port, beam, in any application if there is a Send as command. To send, select Infrared. If you receive a beamed object, a dialog box shows with two options: View or Done. View opens the associated application which shows the object, Done saves it in the Beamed folder in

Messages.

126

Connecting to other devices