For Machines Mfg. Since 8/09

O P E R A T I O N

SB1024/SB1025/SB1026

Control Panel

Use Figures 15–16and the following descriptions to understand the functions of the mill control panel.

 

ON Button

Spindle

Power Lamp

 

Direction

 

Switch

 

 

Emergency

 

STOP

 

OFF Button

Figure 15. Model SB1025 control panel.

ON Button

Power Lamp

Spindle

Direction

Switch

Emergency STOP

OFF Button

Figure 16. Model SB1024/SB1026 control panel.

Spindle Direction Switch: Starts, stops, and reverses the direction of spindle rotation.

Note: The Model SB1025 has two positions for each direction that electronically change the speed of the motor and work in conjunction with the belt housing controls to set the spindle speed range (refer to "To set the spindle speed range for the Model SB1025" on Page 39 for additional details).

ON Button: Allows power flow to the motor. The spindle direction switch must be used to start the spindle rotation.

Power Lamp: Illuminates when the mill is connected to a power source.

Emergency STOP Button: Stops the flow of power to the motor. Twist clockwise until it pops out to reset it, then press the ON button to re-establish power flow to the motor.

OFF Button: Stops power flow to the motor.

Table Movement

The mill table moves in three directions, as illustrated in Figure 17:

ssX-axis (longitudinal) ss 9AXIS CROSS

ss :AXIS VERTICAL

These movements are controlled by table ball

HANDLESDANDETHE :AXIS CRANKE!DDITIONALLY STHEC

table can be moved along the X-axis with the power feed.

X-Axis or Longitudinal Travel

(Left & Right)

Y-Axis or Cross Travel (In & Out)

Z-Axis or Vertical Elevation

(Up & Down)

Figure 17. The directions of table movement.

-29-

Page 31
Image 31
Southbend SB1025, SB1026, SB1024 owner manual Control Panel, Table Movement