SOYO SY-5S manual ET24 Chinese

SiS VGA Driver Installation SY-5STM

11.In the detailed configuration for SiS 5597/5598 drivers, follow the instructions that appear on the screen and make your own choices.

12.After the detailed configuration, you will enter the 3DS main display screen and you may begin your 3D Studio work in the environment you just made.

13.Once completing the detailed configuration, you may enter 3D Studio by typing: \3DS3\3DS <Enter>.

14.To change your video configuration again, follow the procedures mentioned above.

6-4 ET24 (Chinese)

This is an ETen Chinese System Display driver (ETDSPDRV.COM) for SiS VGA chips.

1.To install this driver, Copy “SVGAUTL.EXE” to <drive>:\<directory>, i.e.C:\SiS.

2.In default mode (1024x768x16c, 87Hz Interlaced), this Display Driver will force ET Chinese System to “software scrolling” (scrolling with slower speed). To make use of “hardware scrolling” , you must set the Frame Rate to non-interlaced mode before entering ET Chinese system. Do so by adding the following line to the top of the Autoexec.bat or ET24.bat.file. The last two number of the line correspond with the refresh rate of your monitor:

<drive>:\<directory>\SVGAUTL\F2:60 (for 60Hz non-interlaced mode)

3.You may also use F2:70 and F2:75 for 70Hz and 75Hz non- interlaced modes. Here is an example: “C:\SiS\SVGAUTL\F2:60” to Autoexec.bat or ET24.bat

4.Please note that some monitors may not support 70Hz non- interlaced modes.

90