SOYO SY-5S manual Power On

Quick Installation Guide SY-5STM

Please install the ATX power according to the following pin

assignment:

ATX Power

12V

5VSB

PW-0K

GND

5V

GND

5V

GND

3.3V

3.3V

5V

5V

-5V

GND

GND

GND

PS-ON

GND

-12V

3.3V

ØPay special care to the directionality.

ØMake sure pin 1 is in its position.

Step 13. CMOS Clearing (JP5)

After you have turned off your computer, clear the CMOS memory by momentarily shorting pins 2-3 on jumper JP5, for a few seconds. Then restore JP5 to the initial 1-2 jumper setting in order to recover and retain the default settings.

Step 14. Power On

You have now completed the hardware installation of your mainboard successfully.

1.Turn the power on

2.To enter the BIOS Setup Utility, press the <DEL> key while the system is performing the diagnostic checks,

Note: If you have failed to enter the BIOS, wait until the boot up sequence is completed. Then push the RESET button and press <DEL> key again at the beginning of boot-up, during diagnostic checks.

Repeat this operation until you get the following screen.

25