INSTALLATION INSTRUCTIONS
3.Remove the clevis pin from each wheel (See Drawing Below) and remove the wheels from the frame.
| Rivnut | |
| 4 X 21767 | |
Clevis Pin | Outside of Machine | |
Nut | ||
2 X 24439 | ||
4 X 22154 | ||
| ||
| Leg Leveler | |
Cotter Pin | 4 X 20017 | |
2 X 20047 | Transport Wheel | |
| 2 x 20036 |
4.Help your assistant lower the machine to the floor. Install and adjust the leg levelers as necessary to level the machine (see Above).
5.If your machine was shipped outside North America, it will need additional assembly (if this is not the case, skip to step #6).
•Use the fastener removal tool to remove the 8 fasteners on the back panel.
•Mount both handrails onto the frame as shown in Figure 6.
•Push the console cable assembly through the grommet in the frame and connect it to the main cable assembly (refer to Figure 6).
•Install the console mount onto the handrails (refer to Figure 6).
•Install the console and connect the console cable.
•Reinstall the back panel and go to step #6.
6.Unwrap the power supply assembly from the console and connect the DC power cable from the power supply to the power connector located on the bottom cover.
7.Place the power supply on the floor near an AC wall outlet. To reduce the hazard of electrical shock, place the power supply in a location away from the machine and away from exposure to perspiration. You should not place your power supply on a carpet because it may overheat.
8.Check to be sure that the input AC power rating marked on the power supply matches the available power. If it does not, obtain the matching power supply from StairMaster® Health & Fitness Products, Inc. before proceeding any further.
Page 4
