Switch B-2: Paper-out

When this switch is OFF the printer ignores the paper-out detector and prints down to (and beyond) the bottom edge.

Switch B-4: This switch is used for technical purpose only. Leave this switch ON.

Switch B-5: Printable area

This printer can use two types of printing area format for single sheets (cut forms).

By putting the switch ON (’<TypeA“), the top of the first line of printing will start 1/6inch from the top of the paper, and the printed area will end 1/6 inch from the bottom of the paper.

By putting the switch OFF (“Type B“), the first line of printing will start at one inch from the top of the paper, and the printed area will end to print 6 mm from the bottom of the printer.

Switches -C-l and C-2: Print Mode

These switches select the default print pitch and the fonts as shown below.

Print Mode

c-l

c-2

10CPI DRAFT

ON

ON

10CPI HS DRAFT

ON

OFF

17CPI DRAFT

OFF

ON

10CPI LQ

OFF

OFF

NOTE: If you change these switches after you have saved a macro, these new settings will override the macro setting.

.

52

Page 61
Image 61
Star Micronics NX-2430 manual 10CPI Draft 10CPI HS Draft OFF 17CPI Draft 10CPI LQ