Star Micronics NX-2430 Interface Converter SPC-8K, Connect the Parallel connector to the printer

INTERFACE CONVERTER (SPC-8K)

To run the printer in serial mode, you should use the optional Serial/Parallel Converter (SPC-8K).

The procedure to install the Converter is:

1.Set the DIP switches on the SPC-8K before attaching it to the printer. (See next page for detailed information.)

2.Turn off the power switch and disconnect the power cord from the power source.

3.Disconnect the interface cable if attached.

4.Connect the Parallel connector to the printer.

5.Move both clips inside the extended prongs on the sides of the plug until you hear a click,

-

1

Figure 7-21.Connect the Parallel connector to the printer.

6. Connect the Serial connector to your computer.

NOTE: Place the Converter on a table in order not to damage the cable.

[CORRECTMETHOD][INCORRECTMETHOD]

Figure 7-22.Place the converter on a table,

78