Star Micronics NX-2430 manual Off I Off I Off

I

Switches C-3to C-5:Page Length

Leave these switches ON if you will be using 1l-inch forms. You will need to change the switches if you will be using a different page length as shown below:

Page Length	c-3	c-4	c-5
11 inches/Letter	ON	ON	ON
8 inches	OFF	ON	ON
11.7 inches/A4	ON	OFF	ON
12 inches	OFF	OFF	ON
8.5 inches/Letter	ON	ON	OFF
14 inches/Legal	OFF	ON	OFF
10.5 inches/Executive	ON	OFF	OFF
I 7.25 inchesiExecutivel	OFF I OFF I OFF I

Switch D-1: Character Table

The action of this switch depends on the mode chosen with switch A- 1.

Move this switch OFF to select Italic character table with the Standard/ Epson emulation mode. If you leave this switch to the ON position, in place of italics you will get the graphic characters, international char- acters, and mathematical symbols of IBM character set #2.

In the IBM emulation mode, ON selects character set #2, which has international characters and fewer control words.

OFF selects character set #1, for computers with a 7-bit interface.

Switches D-2 to D-4: IBM Code Page or International Character Set

Except in the Standard Italic character set, these switches select the default character code page as shown below:

IBM Code Page D-2 D-3 D-4 IBMCodePage D-2 D-3 D-4

#437U.S.A. ON ON ON K363CanadianFrenchON ON OFF

#850Multi-lingualOFF ON ON #865Nordic OFF ON OFF

#860Portuguese ON OFF ON (Reserved) ON OFF OFF

#861Icelandic OFF OFF ON (Reserved) OFF OFF OFF