Star Micronics NX-2430 manual Switch Combination Functions, Form feed, Top of form

SWITCH COMBINATION FUNCTIONS

Several additional functions can be achieved by pressing the control panel buttons in combinations.

Top of form

Form feed

Buffer clear/All reset

Figure 4-5.Switch combination functions of control panel

Form feed

If you are using cut forms, this operation ejects the current page. If you are using fanfold forms, it feeds to the top of the next page.

1.Press the I ON LINE I button to set the printer off-line.

2.Press the I PAPER FEED ]button and hold it down. The printer will start

performing successive line feeds.

3. While holding the [ PAPER FEED 1 button down, press the I ON LINE 1 button, then release both buttons at the same time. The printer will smoothly eject the current page.

Top of form

When you power on the printer, the top-of-form position is automatically set to the current position. If this is not where you want the top of the page to be, you can change the top-of-foti position as follows:

1.Press the I ON LINE ] button to set the printer off-line.

2.Move the paper to the desired top-of-form position by pressing the I PAPER FEED ] button, or by performing a forward or reverse micro-feed.

3.Press and hold the I ON LINE ] button.

4.While holding the [ ON LINE ] button down, press the EEEHl button, then release both buttons at the same time. The “-–” message will show on the LCD display, that the top-of-fonm position has been set.

41