8 - 2 - 4 MAIN SYSTEM
1)Remove the bolt (20) and take out float chamber body(18).
D | Remove the main jet(2 1) from. the body( 14) |
2) | |
3) | Reassembly |
| a) Fasten the main jet securely to the body. Otherwise, the fuel may become too rich and cause engine |
| malfunction. |
| b) The bolt tightening torque is 70 |
8-2-5 FLOAT SYSTEM
1)Pull out the floatpin (1 7) and remove the float (1 6 ) and needle valve (25). If the needle valve need be re-
placed, replace it with rubber needle.
Caution: When cleaning the jets, use neither a drill nor a wire (because of possible damage of the orifice which will adversely affect fuel flow). Be sure to use compressed air to blow them clean.
2)When removing the needle valve and flots, gently tap the reverse side using the rod more slender than the float pin and remove because the float pin is calked to the carburetor body.
