(4)Check the wiring through ZCT on the IDLE CONTROL UNIT.

*Single Voltage Type

Make sure that an output wire from main coil is passing through the ZCT on the IDLE CONTROL UNIT.

* Dual Voltage Type

Check that two output wires (black wire and red wire) from main coils are passing through the ZCT on the IDLE CONTROL UNIT in the same direction.

(5) Checking the IDLE CONTROL UNIT (RGV4101)

Check the resistance5 between4 five leads of IDLE CONTROLTetherminalIDEL1UNITCOnumb2NTwithROer3ofLcircuitUNITtester.

IDELCONTROLUNIT OUTPUTWIRE ZCT

Fig. 2-17

Fig. 2-18A

 

 

 

 

Fig. 2-18B

 

 

 

 

 

 

 

 

 

 

 

 

Circuit tester (with battery

 

 

Apply black (minus) needle of the circuit tester

 

 

 

 

 

 

 

 

 

power source 1.5 V)

 

 

 

 

 

 

 

 

 

 

 

1

 

2

3

4

 

5

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1

 

-----------

 

250 kΩ

250 kΩ

 

75 kΩ

 

 

 

 

 

 

 

 

 

 

 

 

 

2

 

 

-----------

 

Apply red (plus) needle

 

 

 

 

 

 

 

 

 

 

 

3

 

250 kΩ

 

 

250 kΩ

 

75 kΩ

of the circuit tester

 

 

 

-----------

 

 

 

 

 

 

 

 

 

 

 

 

 

4

 

250 kΩ

 

250 kΩ

-----------

 

75 kΩ

 

 

 

 

 

 

 

 

 

 

 

 

 

5

 

8.5 kΩ

 

7.8 kΩ

7.8 kΩ

 

-----------

 

 

 

 

 

 

 

 

 

 

 

Table. 2-6

NOTE : The resistance readings vary depending on the types of circuit testers. The above table shows an example of the resistance readings measured by an ordinary analogue circuit tester with 1.5 volt battery power source. It is advisable for you to check the resistance readings using your standard circuit tester and revise the checking table.

- 72 -

Page 75
Image 75
Subaru Robin Power Products RGV4100, RGV6100 service manual Idelcontrolunit Output Wire ZCT