Sun Microsystems 2500 manual Powering On the Array, Before Powering On

C H A P T E R 4

Powering On the Array

This chapter describes initial tray power-on procedures. Perform the following procedures in the order listed:

■“Before Powering On” on page 61

■“Powering On the Array” on page 62

■“Powering Off the Array” on page 63

■“Next Steps” on page 64

Before Powering On

You can set up a Dynamic Host Configuration Protocol (DHCP) server to issue the IP address to each controller. If a DHCP server is not available, the controller tray defaults to internal static IP addresses. (See the Sun StorageTek Common Array Manager Software Installation Guide for information about configuring IP addresses on array controllers.)

For instructions on configuring IP addresses on the array controllers, see “Configuring the IP Address of the Array Controllers” on page 74. For instructions on how to set up the DHCP server, see “Configuring a DHCP Server” on page 81.

61