Sun Microsystems 120, V120 9.3.3 Changing the First Character of the Sequence for Escaping to the lom> Prompt (lom -X), 9.3.4 Stopping the LOM from Sending Reports to the Serial A/LOM Port (lom -E off)

9-12 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
●Toturn the Fault LED off again, type:
9.3.3 Changing the First Character of the Sequence for
Escaping to the lom> Prompt (lom -X)
The character sequence #. (hash, dot) enables you to escape from Solaris to the lom>
prompt.
●Tochange the first character of this default lom escape sequence, type:
where xis the alpha-numeric character you want to use instead of #.
Note – If you are at the console and you type the first character of the LOM escape
sequence (by default this is #), there is a second’s delay before the character appears
on the screen.This is because the system waits to see if you type the dot (.) character
next. And, if you do, the lom> prompt appears. If you do not, the # character
appears. If you want to change the LOM escape character,use a character that is not
included in many console commands. Otherwise the delay between when you strike
the key and when the character appears on the screen may affect your typing at the
console.
9.3.4 Stopping the LOM from Sending Reports to the
Serial A/LOM Port (lom -E off)
LOM event reports can interfere with information you are attempting to send or
receive on the Serial A/LOM port.
●Tostop the LOM device from sending reports to the Serial A/LOM port, type:
#lom -F off
#lom -X x
#lom -E off