7-2 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
7.1 Preparing to Configure the Server
Toperform the initial configuration of the Sun Fire V120 or Netra 120 server, set up
a serial connection using the port labeled Serial A/LOM on the server’s back panel
(see Chapter 6).Make sure you have the server ’s power cord(s) connected (see
Chapter 6).

7.1.1 Using a Terminal Server

●Toaccess the Sun Fire V120 or Netra 120 server from a Sun workstation through a
terminal server, open a terminal session on the Sun workstation and type:
For example, for a Sun FireV120 server connected to port 10000 on a terminal server
whose IP address is 192.20.30.10, you would type:

7.1.2 Configuring From a Terminal or Workstation

●Toaccess the server from a dumb terminal, set up a connection between the
terminal and the server.
●Toaccess the server from a Sun workstation that is directly connected to the
server,set up the connections between the devices, then open a terminal session
and type:
The tip command above assumes that your console is using its ttya port. If you
later configureyour console to use its ttyb port, you will need to type the following
to set up a tip session:
#telnet IP-address-of-terminal-server port-number
#telnet 192.20.30.10 10000
#tip /dev/term/a -9600
#tip /dev/term/b -9600