Sunfire Radio manual Operating the Ultimate Receiver with the Remote, Zone AUX

CHAPTER 3

Operating the Ultimate Receiver with the Remote

1.Press the remote's MAIN button to make sure the display is on the main display menu.

2.Press the RECVR

device button to set the remote to operate your Re- ceiver. The display changes to show the Receiver input

	SYSTEM	POWER
	OFF
	MAIN
	CD	DVD
	TAPE	VCR
ZONE 2	AUX	SAT
	ZONE2	TV

selections:

3.Press PAGE to reach page 2, which shows the DOLBY PRO LOGIC-II,

PARTY, STEREO, HOLOGRAM, and the trims for center, surrounds, and sub.

RECVR	RECVR CABLE
MAIN		AUDIO
PAGE	PAGE	MAIN	FAV
		PREV
		CH
	VOL		CH
		MUTE
Use the Joystick to navigate	GUIDE		MENU
through the OSD (when active)
	MODE		MODE

Hold down MAIN and ENT for a few seconds to enter the SETUP mode. See next page.

Full-page On Screen

Display (OSD)

On the right is '+' (increase level) and on the left is '-' (decrease level).

4. The following buttons with Þxed

lables are also programmed: Pow-

er, Volume up, down and Mute.

The number pad accesses the

tuner presets directly, and CH+/-

Previous Mode

OSD Exit

			Next Mode
EXIT		INFO	Momentary status and
1		3
	2		information display
4	5	6
7	8	9

steps through them. DIS is the +10

function, and ENT is station enter.

The MODE buttons either side of

the joystick, allow you to select the

different surround modes.

ZONE 2

Note: Zone 2 must Þrst be enabled using the OSD (see page 36), or these controls will have no effect. Zone 2 can be turned on even if the Main Zone is off.

See page 47 for more Zone 2 details.

26

+10

DIS 0 ENT

M1 M2 M3

1. From the main	3. Page 2 shows
display menu,	Zone 2 on/off,
press the ZONE2	Zone 1 on/off,
device button to	and balance left/
access features	right.
of the second
zone. Page 1
shows the input
selections.

2.The hard buttons operate Zone 2, such as Power, Volume, Mute, and the Tuner controls and presets.

User's Manual