Sunfire Radio manual Video, Software and Control Menus, Software Menu

CHAPTER 4

Video, Software and Control Menus

MAIN MENU
TRIMS	SETTINGS
MODES
TONE	MAIN ZONE
INPUTS
	ZONE 2
SETTINGS
	SPEAKERS
	VIDEO
	SOFTWARE
	CONTROL
Video Menu	AMPLIFIER
	VIDEO MENU

OSD POP UP
	OSD VOL POP UP		ENABLE
(VOL, SOURCE, and MODE)
When enabled, an on-screen	OSD SOURCE POP UP ENABLE
	OSD MODE POP UP		ENABLE
message appears any time the
	VID DEFAULT		COMP
Volume (or Mute, on-the-ßy-
	VID2/MON2 OUT		VID2
Trims), Source, and Surround
	VID DELAY		0 MS
Mode are changed.
The OSD popups can be set to		INFO DISPLAY ENABLED
show only Volume, only Source,		and the output is muted when
only Mode, or any combination
		VID2 is chosen as an input (to
of the three, by setting the menu
		prevent feedback).
item to Enable. When all three are
disabled, the Info button is also		MON2: the VCR2/MON2 output
disabled, and a message appears
		becomes a second monitor output
on the bottom of this menu. With
		(with OSD) for another TV. It will
all three disabled, the video signal
		not mute when VID2 is chosen.
uses the purest path possible to
	VIDEO DELAY
route to the monitor. For example,
if you are set to an S-video input		This adjustment is useful if you
and the monitor is on it’s		have an external video processor
S-video feed, then the video is not		in your system. Video signals may
digitized in the Ultimate Receiver.		become delayed with respect to
If you are up-converting from a		the audio signals. Although it is
composite video source, or you		called Video Delay, it is actually a
have pop-ups enabled, then the		delay adjustment of the audio sig-
video path for S-video will always		nals relative to the video signals.
be digitized for smoothest viewing		Use the remote's joystick pad to
transitions for the OSD popups.
		adjust the delay in one millisecond
VIDEO DEFAULT		steps. An equal amount of delay
Select the video output where the		time is added to all audio chan-
"pop-up" text appears, either S		nels.
or composite video, but not both.	Note: The speakers keep their rela-
The full OSD is not affected, as it
		tive time delay settings which the
is available on both.
		Ultimate Receiver calculates
VID2/MON2 OUT		from the Speaker Position Menu
VID2: the VCR2/MON2 outputs		settings. The video delay is just
can be used for recording to a		added on top. Leave the video de-
second VCR. There is no OSD,		lay at zero if you have no external
		video processor.

User's Manual

SOFTWARE

UPGRADE SOFTWARE

REVISION LIST

CONTROL

RS-232	ENABLE
REAR MAIN IR	ENABLE
REAR ZONE 2 IR	ENABLE
FRONT PANEL IR	ENABLE

Software Menu

This menu is used to show the cur- rent revision levels of system software within your Ultimate Receiver.

It also allows the Flash memory software to be upgraded by CD, see page 48 for details.

Control Menu

In most cases, there is no need to change these settings (all enabled by default). You should make any chang- es with caution.

This menu allows you to enable or disable the RS-232 port and the rear panel IR remote control connections. The front panel IR receiver can also be disabled if required, but make sure the rear panel IR receiver is working correctly and is still active before do- ing this.

The front panel IR can be re-en- abled by holding down the remote's MENU button for several seconds, while pointing it at the front IR window.

37