Chapter 6: Advanced Chassis Setup

6-5

Installing 2.5" Hard Drives
2.5" hard drives may be installed in several different congurations. Review the
supported conguration options on page 6-6.
1. Power down the server, disconnect the power cord from the power supply and
remove the cover.
2. Install up to four 2.5" hard drive(s) into the hard drive bracket(s) and secure
them to the bracket with the screws provided. (See page 6-6 for supported
conguration options.)
3. Place the hard drive and bracket into the chassis as illustrated in Figure 6-3.
If up to four 2.5" hard drives are desired, rotate the hard drive brackets ninety
degrees and place them side by side before attaching them to the chassis.
4. Secure the hard drive bracket(s) to the chassis oor by inserting the screws
up through the underside of the chassis.
5. Expansion cards must be installed after installing the 2.5" hard drives.
6. Connect the hard drive wiring, reinstall the chassis cover and power cord,
then power up the server
Note: bracket part number is MCP-220-000440N