SUPER MICRO Computer 5017P-TLN4F, 5017P-TF user manual Replacing the Power Supply

Chapter 6: Advanced Chassis Setup

6-7 Power Supply

The SC504 chassis has a 200 Watt power supply. This power supply is auto-switch- ing capable. This enables it to automatically sense and operate at a 100v to 240v input voltage.In the unlikely event that the power supply module fails, the system will shut down and you will need to replace the power supply module. New units can be ordered directly from Supermicro (see contact information in the Preface).

Replacing the Power Supply

Replacing the Power Supply

1.Power down the system, disconnect the power cord and remove the chassis cover.

2.Disconnect all wiring from the power supply.

3.Remove the four screws which hold the power supply in the chassis. Two rear mounting screws are located on the rear of the power supply. Two bottom mounting screws are accessed on the underside of the chassis and extend upwards through the mounting thru holes, to hold the power supply in place. Set the screws aside for later use.

Power Supply

Mounting Thru Holes

Insert Bottom

Mounting Screws

from Underside

Rear Mounting

Screws

Figure 6-8. Installing the Power Supply

6-9