Chapter 5: Advanced Serverboard Setup
Figure 5-1. 604-pin PGA Socket: Empty and with Processor Installed
! |
Warning! Make sure you lift the lever completely when in- stalling the CPU. If the lever is only partly raised, damage to the socket or CPU may result.
Empty socket | With processor installed |
Lever
Triangle (pin 1) | Triangle locating pin 1 |
Heatsink Installation
1.Do not apply any thermal compound to the heatsink or the CPU die; the required amount has already been applied.
2.Place the heatsink on top of the CPU so that the four mounting holes are aligned with those on the retention mechanism.
3.Screw in two diagonal screws until snug (do not fully tighten the screws to avoid possible damage to the CPU). Then screw in the other two diagonal screws until snug. See Figure
4.Finish the installation by fully tightening all four screws.
*The heatsink
