SUPER
2-8 Jumper Settings
Explanation of
Jumpers
To modify the operation of the motherboard, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. See the motherboard layout pages for jumper locations.
Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins.
Connector | 3 2 1 |
|
| ||
Pins |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
Jumper
Cap
3 2 1
Setting
Pin
CMOS Clear
JBT1 is used to clear CMOS (which will also clear any passwords). Instead of pins, this jumper consists of contact pads to prevent accidentally clearing the contents of CMOS.
To clear CMOS, first power down the system, then
1)Unplug the power cord(s)
2)With the power disconnected, short the CMOS pads with a metal object such as a small screwdriver
3)Remove the screwdriver (or shorting device)
4)Reconnect the power cord(s) and power on the system.
Note: Do not use the PW_ON connector to clear CMOS.
SpeakerEnable/Disable (X5DL8-GG)
To enable use of the onboard speaker, put a jumper on pins 13 and 15 of JF2. Removing the jumper will disable the onboard speaker.
