SUPER
2-2 PGA Processor and Heatsink Installation
When handling the processor package, avoid placing direct pressure on the label area of the fan. Also, do not place the
!motherboard on a conductive surface, which can damage the BIOS battery and prevent the system from booting up.
IMPORTANT: Always connect the power cord last and always remove it before adding, removing or changing any hardware components. Make sure that you install the processor into the CPU socket before you install the CPU heat sink. Note: pictures show
1.Locate the following components, which are included in the shipping package.
Clips (2) |
| Screws* (4) |
| ||
Retention brackets |
|
|
(2) |
| Black anchors (4) |
|
| |
|
| |
|
| White pegs (4) |
*These screws are for mounting the motherboard to the back panel of a chassis that has four mounting holes (as shown on right).
For chassis that do not have four mounting holes, use the anchor/peg assemblies:
2.Insert the white pegs into the black anchors. Do not force the white pegs all the way in - only about 1/3 of the way into the black anchors.
3.Place a retention bracket in the proper position and secure it by pressing pegs into two of the retention holes until you hear a *click*. The clicking sound indicates that the peg is locked and secured.
Anchor/peg assemblies
Two pegs in position
One retention bracket in position
