Taiwan Electrical & Electronic Manufacturers N930R manual System Upgrade, Memory Upgrade

English

System Upgrade

This section provides some steps in doing system upgrade for your notebook computer. The upgrade procedures include the following:

7.1 Memory Upgrade

Your notebook computer offers 200-pin SODIMM (Small Outline Dual Inline Memory Module) at least 256MB DDR2-SDRAM. The memory compartment is located inside your computer. The table below lists the possible combinations of different memory module and memory size.

•Please contact dealer for changing or adding DDR2-SDRAM module. It is not avai lable for users to change it by themselves.

Based Memory	Installing Memory	Total
256 MB	0 MB	256 MB
256 MB	256 MB	512 MB
256 MB	512 MB	768 MB
256 MB	1024 MB	1280 MB
512 MB	0 MB	512 MB
512 MB	256 MB	768 MB
512 MB	512 MB	1024 MB
512 MB	1024MB	1536 MB
1024MB	0 MB	1024 MB
1024MB	256 MB	1280 MB
1024MB	512 MB	1536 MB
1024MB	1024MB	2048 MB

INSTALLING MEMORY MODULE

Your computer comes with standard 256 MB, 512MB or 1024MB of synchronous DDR2 SDRAM. You can increase system memory to a maximum of 2048 MB in the system, by installing two small outline double inline memory modules (SO-DIMMs) with installed base memory in the system.

The 256MB, 512MB and 1024MB memory modules are available: To install the memory module:

1.Make sure the system is powered off, the battery also is removed and that no peripheral devices are attached.

2.Turn the computer upside-down and locate the screw that secures the DIMM door at the underside of the notebook.