Advanced use | TANDBERG Videoconferencing System |
Audio Outputs
Audio out 1 is intended for connection to televisions or audio amplifiers.
Audio out 2 is intended for connection to audio recording equipment or to a telephone
Audio out 3 is intended for connection to a VCR or other recording equipment. The signal is a mix of audio from far end and local end (not from Audio in 4).
NOTE
NEVER CONNECT AUDIO OUT 2 OR AUDIO OUT 3 TO A LOUDSPEAKER PLACED IN THE SAME ROOM AS THE MICROPHONES CONNECTED TO THE SYSTEM. DOING THIS WILL CAUSE “HOWLING” AND POSSIBLE DAMAGE TO THE SPEAKER SYSTEM.
If an output is ‘Off’, no audio will be sent to that output.
Level Settings - Outputs
Level Settings |
|
|
Out1: | — | +13.5dB |
Out2(AUX): | — +13.5dB | |
Out3(VCR): | — | +13.5dB |
Previous Menu |
|
|
Adjust the audio output levels according to the parameters of the external audio equipment connected. These levels should only be adjusted when installing new audio equipment. The default settings are correct for the TANDBERG Natural Audio module and for most consumer electronics devices (televisions, VCRs, etc.).
The volume keys on the remote control adjust the level of output 1 (the speaker output). The volume control has no effect on outputs 2 and 3.
60
