Codec C90
ContentsIntroduction
Administrator Guide
| GetGettinging startstarted | About the menus | About the settings | Settings Library | Cameras | Appendices | Contact us |
|
|
|
|
|
|
|
|
1 | Turn on the system | |
• | Turn on the codec and wait a few minutes for the system to start | |
| • Make sure the remote control has the batteries installed. | |
| • | Press Home ( ) on the remote control to show the menu on screen |
| • When you can see the menu on screen, proceed to Step 2. | |
Show the menu:
•Press Home ( 
) on the remote control to show the menu on screen
Navigate in the menu:
•Use the arrow keys on the remote control to navigate up and down in the menus
Confirm your choice:
| • | To confirm your choice, press OK ( ) on the remote control |
|
| |
|
| |
2 | Verify IP address settings | |
Go to System Information to verify the IP address: | ||
| 1. | Navigate to Settings > System Information |
| 2. | When the IP address is automatically assigned from a DHCP server, the |
|
| Address of the codec is shown on the System Information page. |
| 3. | Press Home ( ) to exit. |
|
|
|
3 | If you need to set a static IP address | |
Go to IP Settings to set static IP addresses: | ||
| 1. Navigate to Settings > Administrator Settings > IP Settings. | |
| 2. | Set IP Assignment to Static. Press the left arrow key to go back one step |
| 3. | Enter the IP Address, Subnet Mask and Gateway address in the address fields. |
|
| The sequence is shown below. |
| 4. | Press OK to save the changes, or Cancel to leave without saving. |
| 5. | Press Home ( ) to exit. |
11 |
