IFU Nutricook SEB TEFAL_9L 4135696:4135696 4/01/10 14:58 Page 60
•To make it easier to use your NutriCook, the timer is there to help and guide you through your recipes.
Fitting and removing the timerEN
•To fit the timer (C)Fig. 7, first insert the rear part, then clip down the front part.
•To remove the timer (C), press the tab and lift it.
Cooking always takes place in two phases:
•The duration of the first pressure phase is directly linked to the chosen recipe or the kind of ingredients to be cooked, and this is the time you need to programme on the timer using the – and + buttons.
•The second soft cooking phase is
•You can switch the timer off at any time by pressing simultaneously on both buttons.
•During cooking you can change the cooking time only if the timer is positionned on the NutriCook. During the soft steam phase, you cannot modify the cooking time.
1 |
|
| 2 |
|
I put the |
| I close |
| I select a |
ingredients | NutriCook® | programme | ||
3 |
| 4 | 0 | MAXI |
I programme |
|
| I turn on the heat, | |
the cooking time |
| to full power |
NutriCook heats up
Rear part
Front part Tab
Never open your NutriCook before the end of the soft cooking phase, as you could stop the cooking process before the ingredients are fully cooked. Refer to the "End of cooking" heading.
Heat source at max.
Programmed time set
Steam is released:
The timer beeps to show that pressure cooking is starting (phase 1)
| Heat source |
| at reduced |
0MAXI |
|
I turn down the heat so | Cooking |
there is a constant, | time |
steady release of steam. | counts down |
55