Tefal P4221435 Using NutriCook, Before cooking, During cooking, Finishing cooking, Selector F to

IFU Nutricook SEB TEFAL_9L 4135696:4135696 4/01/10 14:58 Page 63

Using NutriCook

Before cooking

• Every time you use your cooker, first check that the control module is correctly fitted and tightened (using a coin) and check that the operating valve (L) located inside the lid can move, by moving the programme

selector (F) to	and pressing the valve with your
finger. Fig. 17.

•Also check that the safety valve (M) can move: see Fig. 18 and refer to the "Cleaning and Maintenance" heading.

•Close the NutriCook.

•Move the selector to one of the programmes as shown in your recipe book. Fig. 9.

•Programme the timer for the cooking time shown for your recipe. Fig. 10.

•Place the NutriCook on a heat source set to maximum power.

decompression valve

EN

Always position the NutriCook so that the programme selector (F) faces you.

Just like for any other cooking appliance, always pay close attention to it, especially when using NutriCook near children.

The steam jet coming from the steam release outlet (A) is very hot.

During cooking

•When the signal sounds, the timer indicates that you need to turn the heat down so there is a constant,

steady release of steam.

➩Pressure cooking starts and the timer counts down.

• Once the pressure cooking phase is finished, the signal sounds and the timer indicates that you need to turn off the heat and move the cooking programme selector to . Fig. 8.

• A jet of hot steam, and possibly droplets of water, escapes from the steam outlet (A) in a vertical direction.

➩The soft pressure cooking phase starts (this time is

ready programmed).

•If you accidentally open your NutriCook during the soft cooking phase, close it back up immediately, and this will have no effect on cooking.

•Never remove the timer during the pressure cooking or soft pressure cooking phases.

Finishing cooking

•When the soft pressure cooking phase is finished, the timer's signal sounds indicating that cooking is finished. .

•Check that the pressure indicator (D) has dropped back down.

•Raise the Open/Close handle to the vertical position to open the lid. Fig.1.

To move NutriCook, use the carrying handles on the side of the cooker.

58