Installation
1-18 CSA7000 Series, TDS7000 Series, & TDS6000 Series Instruments User Manual
6. Watch for a message on the external monitor telling you that Windows has
successfully initialized the display adapter.
7. The instrument should detect that the new monitor was connected. Follow
the instructions on the instrument display to install new drivers for the
monitor.
8. Type a Control-M to minimize the instrument application.
9. In the Windows desktop, right-click the mouse, and then select Properties to
display the Display Properties dialog box.
10. Select the Settings tab, and click the grayed-out monitor in the display box.
11. Click yes when you are prompted to enable the new monitor.
12. Set the resolution that you want to use on the external monitor.
13. Click on the external monitor in the display box, and drag it to the correct
orientation.
CAUTION. Do not change the resolution or color settings for the internal LCD
monitor. The internal resolution must be 640 x 480 and the color setting must be
High Color (24 bit).
14. Click OK to apply the settings. The new monitor will display additional
desktop area.
To make the best use of the new display area, do these additional steps to move
the Windows controls to the external monitor:
1. Click (and hold) on the Windows task bar in the area shown in Figure 1--5,
and then drag it upwards and toward the external monitor. The task bar will
first go to the side of the internal monitor, then to the side of the external
monitor, and finally to the bottom of the external monitor.