Teledyne API T802 Paramagnetic O2 Analyzer Operation Manual Basic Operation
67
4.4. SETUP MODE
The SETUP mode contains a variety of choices that are used to configure the
analyzer’s hardware and software features, perform diagnostic procedures, gather
information on the instrument’s performance and configure or access data from
the internal data acquisition system (DAS). SETUP mode has a Primary and a
Secondary setup menu.
Note Any changes made to a variable during one of the SETUP procedures are not
acknowledged by the instrument until the ENTR button is pressed. If the EXIT
button is pressed before the ENTR button, the analyzer will beep to notify the
user that the newly entered value has been lost.
Setup Mode can be protected by password security through the SETUP>PASS
menu (Section 5.5) to prevent unauthorized or inadvertent configuration
adjustments.

4.4.1. PRIMARY SETUP MENU

For a visual representation of the software menu trees, refer to Appendix A-1.
The areas accessible under the SETUP mode are shown below:
Table 6-4: Primary Setup Mode Features and Functions
MODE OR FEATURE MENU
ITEM DESCRIPTION MANUAL
SECTION
Analyzer Configuration CFG Lists key hardware and software configuration information 5.1
Auto Cal Feature ACAL (Special configuration; consult factory). 11.9
Internal Data Acquisition DAS Used to set up the DAS system and view recorded data 7
Analog Output Reporting
Range Configuration RNGE Used to configure the output signals generated by the
instruments Analog outputs. 5.4
Calibration Password
Security PASS Turns the calibration password feature ON/OFF 5.5
Internal Clock Configuration CLK Used to Set or adjust the instrument’s internal clock 5.6
Advanced SETUP features MORE This button accesses the instrument’s secondary setup
menu
See
Table 6-5
07275B DCN6418