Tiger Products Co., Ltd TS 100A Maintenance Regular Maintenance, DAILY OR EVERY 8 HOURS, Service

MAINTENANCE

REGULAR MAINTENANCE

The intervals at which regular servicing should be done are based on hours of operation. Use the tractors hour meter to determine when regular servicing is required.

This symbol indicates a point that needs to be greased at an interval noted in the section below. Refer to the Detailed Maintenance section for further instructions on greasing. Copy and use the Daily Maintenance sheet located at the end of this section.

DAILY OR EVERY 8 HOURS

ITEM	SERVICE	COMMENTS
Drive Shaft Yoke, U-Joint	Grease	Grease as instructed in
& Stub Shaft		detailed maint. section
Pump Drive Shaft	Check and Lube	Insure drive shaft end play
Crankshaft Adapter	Check rubber grommets	Replace grommets if
		damaged or missing
Pivot Points	Lubricate	Inject grease until it appears
		at ends
Hydraulic Fittings	Check for leaks	Tighten when needed. Do Not
		use hands to check for leaks,
		see maintenance precautions
Knives	Check	Inspect for missing or
		damaged knives, change
		or sharpen as needed
Spindle mounting bolts	Check	3/4” x 2” torque to 331 ft. lbs.
(spindle to deck)
Knife mounting bolts	Check	Pre-lubricate threads, then
(knife to disk)		torque to 800 ft.lbs
Disk mounting bolts	Check	5/8” x 1-3/4” bolt to torque
(disk to spindle)		204 dry or 184 oiled ft. lbs.
Belts	Check / Adjust	Check if broken, tighten
		as required
Main Frame and	Check	Retorque bolts to torque
Deck		specifications in this section
Hydraulic Fluid Level	Check	Add if required per fluid
		recommendations

Maintenance Section 4-3