MAINTENANCE
DAILY MAINTENANCE SCHEDULE
The following services should be performed daily or every 8 hours of service, following the detailed maintenance instructions in the operators manual.
______ | Pump Drive Shaft: Check for end play in drive shaft / coupler and | |
| lubricate at zerks. | |
______ | Crankshaft adapter: If equipped with rubber grommets check | |
| condition, replace if missing or damaged. | |
______ | Pivot points: Inject grease until it appears at ends. | |
______ | Hydraulic fittings: Check for leaks with paper or cardboard. Tighten | |
| fittings or replace hoses immediately. | |
______ | Knives: Inspect for missing or damaged knives, change (only | |
| complete sets) as needed. | |
______ | Belts: Check / Tighten / Replace belts as needed. | |
______ | Main Frame / Deck: Unless otherwise specified retorque bolts | |
| according to torque specifications in this | |
| section. | |
______ | Hydraulic Fluid Level: Add, if required, per fluid recommendations. | |
______ | Rear Flail Drive, Bearing |
|
| Flange and Shaft Couplers: Grease as instructed in the detailed | |
| (if applicable) | maintenance section. |
______ | Cutter Shaft and Ground Roller: Grease as instructed in the detailed | |
|
| maintenance section |
Service | performed by:_______ | Date:____/____/____ Hour |
Meter:__________ |
| |
Maintenance Section
** This page may be copied and used as part of the daily maintenance routine.
Maintenance Section
