Getting started
This is a
1)Setup your network as shown in the setup diagram above (fig 1.2).
2)You then need to set your LAN PC clients so that it can obtain an IP address automatically. All LAN clients require an IP address. Just like an address, it allows LAN clients to find one another. (If you have already configured your PC to obtain an IP automatically then proceed to step 3, page 11)
Configure your PC to obtain an IP address automatically
By default the broadband router’s DHCP is on, this means that you can obtain an IP address automatically once you’ve configured your PC to obtain an IP address automatically. This section will show you how to configure your PC’s so that it can obtain an IP address automatically for either Windows 95/98/Me, 2000 or NT operating systems. For other operating systems (Macintosh, Sun, etc.), follow the manufacturer’s instructions. The following is a
2a) Windows 95/98/Me
1:Click the Start button and select Settings, then click Control Panel. The Control Panel window will appear.
2:
3:Check your list of Network Components. If TCP/IP is not installed, click the Add button to install it now. If TCP/IP is installed, go to step 6.
4:In the Network Component Type dialog box, select Protocol and click Add button.
5:In the Select Network Protocol dialog box, select Microsoft and TCP/IP and then click the OK button to start installing the TCP/IP protocol. You may need your Windows CD to complete the installation.
6:After installing TCP/IP, go back to the Network dialog box. Select TCP/IP from the list of Network Components and then click the Properties button.
7:Check each of the tabs and verify the following settings:
ξBindings: Check Client for Microsoft Networks and File and printer sharing for Microsoft Networks.
ξGateway: All fields are blank.
ξDNS Configuration: Select Disable DNS.
ξWINS Configuration: Select Disable WINS Resolution.
ξIP Address: Select Obtain IP address automatically.
8
