Seat Switch (Fig. 9)

1.Disconnect the seat switch wire connector and install a continuity tester or ohm meter between the two leads of the seat switch.

2.Lower the seat. The continuity tester should show no continuity.

3.Have the operator sit on the seat, slowly depressing the seat switch. The continuity tester should indicate a reading as the seat approaches the bottom of its travel.

NOTE: Make sure the compression spring and pin hold the seat up off the seat switch when there is on operator on the seat.

1

Figure 9

1. Seat switch

Traction (Neutral) Switch (Fig. 10)

1.Disconnect the traction switch wire connector and install a continuity tester or ohm meter between the two leads of the traction switch.

2.Make sure the shift selector is in the neutral (N) position. There should be continuity when the shift selector is in the neutral (N) position. If there is no continuity adjust or replace the switch. (See Traction (Neutral) Switch Replacement and Adjustment in the Repairs section of this book.)

3.Move the shift selector to the No.1 and No. 2 posi- tions. There should not continuity when shift selector is in either of these positions. If there is continuity adjust or replace the switch. (See Traction (Neutral) Switch Replacement and Adjustment in the Repairs section of this book.)

1

Figure 10

1. Traction (neutral) switch (on bottom of valve bank)

Testing

Page 5 - 10

Greensmaster® 3100

Page 118
Image 118
Toro 3100 manual Seat Switch Fig, Traction Neutral Switch Fig