14.Install 1-1/4" diameter dust seal in seal gland bush- ing, flat or smooth side of dust seal must face down towards bushing, see Fig. 60.

15.Install the quad-ring seal in seal gland bushing. Smooth seal in place with your finger. Do not use any seal that falls freely into pocket of bushing, see Fig. 60.

16.Install seal gland bushing over the spool end with a twisting motion. Tap the bushing in place with a rubber hammer. Make sure the bushing is flush against the bearing race.

17.Install retaining ring (see Fig. 59 - 60) in housing. After installing ring, tap on ring end or pry with screw- driver around entire circumference of ring to properly seat ring in groove.

Figure 59

Figure 60

Repairs

Page 4 - 68

Greensmaster® 3100

Page 96
Image 96
Toro 3100 manual Repairs Greensmaster