Connecting the Power Cord | Toshiba B-SX5T SERIES, BSX5TTS25QMR

2. PRINTER SETUP

ENGLISH VERSION EO1-33036

2.5 Connecting the Power Cord

2.5Connecting the Power Cord

CAUTION!

1.Make sure that the printer Power Switch is turned to the OFF position ({) before connecting the Power Cord to prevent possible electric shock or damage to the printer.

2.Use only the Power Cord supplied with the printer. Use of any other cord may cause electric shock or fire.

3.Connect the Power Cord to a supply outlet with a properly grounded (earthed) connection.

1. Make sure that the printer Power Switch is in the OFF ( ) position.

Power Switch

2.Connect the Power Cord to the printer as shown in the figure below.

Power Cord

3.Plug the other end of the Power Cord into a grounded outlet as shown in the figure below.

Power Cord	Power Cord

[QQ Type]

[QP Type]

E2- 4

Image 14

Toshiba B-SX5T SERIES, BSX5TTS25QMR, BSX5TTS22QMR owner manual Connecting the Power Cord

Contents

SX5T Series CE Compliance for EU only Vorsicht Wkhsoxj Precautions Request Regarding Maintenance Table of Contents EA3-1 EA1-1EA2-1 EA4-1 Unpacking Introduction FeaturesProduct Overview Accessories Front View DimensionsAppearance Rear View Operation Panel Interior Printer Setup Precautions Procedure before Operation Connecting the Cables to Your Printer Gori Connecting the Power Cord Turning OFF the Printer Turning the PrinterTurning on the Printer Loading the Media Parts, be sure to load Do not over-tighten the Locking Ring of the Supply Holder Setting the Feed Gap Sensor position Setting the Black Mark Sensor position STANDARD/PEEL OFF position Batch modeStrip mode Build-in rewinder mode Adjustment Cut mode Loading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards 3517 Test Print $5&2 Printer’s power OFF then back to on and check that the LCD Sample of the bar code test print label On Line Mode Operation Panel Reset Operation Dump Mode Print Head/Platen/ Sensors MaintenanceCleaning Covers and Panels Care/Handling of the Media and Ribbon Optional Cutter Module Error Messages Problems/Causes Solutions TroubleshootingError Messages Restart key Possible Problems Causes Solutions Possible ProblemsError Messages Problems/Cause Solutions Removing Jammed Media Do not use any tool that may damage the Print Head Threshold Setting Threshold setting procedure Model Appendix 1 SpecificationsA1.1 Printer A1.3.1 Media Type A1.2 OptionsA1.3 Media Label A1.3.2 Detection Area of the Transmissive Sensor Label Tag paper with square holes A1.3.3 Detection Area of the Reflective SensorA1.3.4 Effective Print Area A1.4 Ribbon Figure below shows the effective print area on the media Symbols in the message Appendix 2 Messages and Leds 67$9$ Appendix 3 Interface „Interface Cables Appendix 4 Print Samples EAN13+2 digits Interleaved 2 CODE39 StandardJAN13, EAN13 EAN13+5 digits UPC-A+5 digits Industrial 2 Glossaries Bar code Print head element USB Universal Serial Bus Index Index Page Page EO1-33036B