Accessories | Toshiba B-SX5T SERIES, BSX5TTS25QMR, BSX5TTS22QMR

1. PRODUCT OVERVIEW

ENGLISH VERSION EO1-33036

1.4 Accessories

1.4Accessories

When unpacking the printer, please make sure all the following accessories are supplied with the printer.

U

US Power Cord (1 pc.) (P/No. FBCB0030203) QQ model only

U

CD-ROM (1 pc.)

QQ(P/No.: 7FM00332100) QP (P/No.: 7FM00256100)

UEU Power Cord (1 pc.) (P/No.EKA-0030001)

UQP model only

Fan Filter (1 pc.) (P/No. FMBB0036801)

U

Rewinder Guide Plate (1 pc.)	USMW-4x8 Sems Screws (2 pcs.)
(P/No.: FMBD0034501)	(P/No.: X0-00161000)

U

Warranty Disclaimer Sheet (1 sheet)

QQ-US model only

E1- 2

Image 8

Toshiba B-SX5T SERIES, BSX5TTS25QMR, BSX5TTS22QMR owner manual Accessories

Contents

SX5T Series CE Compliance for EU only Vorsicht Wkhsoxj Precautions Request Regarding Maintenance Table of Contents EA1-1 EA2-1EA3-1 EA4-1 Unpacking Introduction FeaturesProduct Overview Accessories Dimensions AppearanceFront View Rear View Operation Panel Interior Printer Setup Precautions Procedure before Operation Connecting the Cables to Your Printer Gori Connecting the Power Cord Turning OFF the Printer Turning the PrinterTurning on the Printer Loading the Media Parts, be sure to load Do not over-tighten the Locking Ring of the Supply Holder Setting the Feed Gap Sensor position Setting the Black Mark Sensor position STANDARD/PEEL OFF position Batch modeStrip mode Build-in rewinder mode Adjustment Cut mode Loading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards 3517 Test Print $5&2 Printer’s power OFF then back to on and check that the LCD Sample of the bar code test print label On Line Mode Operation Panel Reset Operation Dump Mode Print Head/Platen/ Sensors MaintenanceCleaning Covers and Panels Care/Handling of the Media and Ribbon Optional Cutter Module Troubleshooting Error MessagesError Messages Problems/Causes Solutions Restart key Possible Problems Causes Solutions Possible ProblemsError Messages Problems/Cause Solutions Removing Jammed Media Do not use any tool that may damage the Print Head Threshold Setting Threshold setting procedure Model Appendix 1 SpecificationsA1.1 Printer A1.2 Options A1.3 MediaA1.3.1 Media Type Label A1.3.2 Detection Area of the Transmissive Sensor Label Tag paper with square holes A1.3.3 Detection Area of the Reflective SensorA1.3.4 Effective Print Area A1.4 Ribbon Figure below shows the effective print area on the media Symbols in the message Appendix 2 Messages and Leds 67$9$ Appendix 3 Interface „Interface Cables Appendix 4 Print Samples Interleaved 2 CODE39 Standard JAN13, EAN13EAN13+2 digits EAN13+5 digits UPC-A+5 digits Industrial 2 Glossaries Bar code Print head element USB Universal Serial Bus Index Index Page Page EO1-33036B