Toshiba B-SX5T SERIES, BSX5TTS25QMR, BSX5TTS22QMR specification

2. PRINTER SETUP

ENGLISH VERSION EO1-33036

2.7 Loading the Media

2.7Loading the Media (Cont.)

NOTE:

Do not over-tighten the Locking Ring of the Supply Holder.

5.Put the media on the Supply Shaft.

6.Pass the media around the Damper, then pull the media towards the front of the printer.

7.Align the projection of the Supply Holder with the groove of the Supply Shaft, and push the Supply Holder against the media until the media is held firmly in place. This will centre the media automatically.

Then turn the Locking Ring clockwise to secure the Supply Holder.

Groove Damper

Supply Holder

Projection

	Media			Supply Shaft			Locking Ring
							Locking Ring

In case of a label rolled with						In case of a label rolled with
the print side facing inside.						the print side facing outside.

MediaDamper

8.Place the media between the Media Guides, adjust the Media Guides to the media width, and tighten the Locking Screw.

9.Check that the media path through the printer is straight. The media should be centred under the Print Head.

Media Guide

Print Head

Supply Holder

Locking Screw	Media	Media Guide

E2- 7

Image 17

Toshiba B-SX5T SERIES, BSX5TTS25QMR, BSX5TTS22QMR owner manual Do not over-tighten the Locking Ring of the Supply Holder

Contents

SX5T Series Vorsicht CE Compliance for EU only Wkhsoxj Request Regarding Maintenance Precautions Table of Contents EA2-1 EA1-1EA3-1 EA4-1 Unpacking Introduction FeaturesProduct Overview Accessories Appearance DimensionsFront View Rear View Interior Operation Panel Precautions Printer Setup Procedure before Operation Gori Connecting the Cables to Your Printer Connecting the Power Cord Turning OFF the Printer Turning the PrinterTurning on the Printer Parts, be sure to load Loading the Media Do not over-tighten the Locking Ring of the Supply Holder Setting the Black Mark Sensor position Setting the Feed Gap Sensor position STANDARD/PEEL OFF position Batch modeStrip mode Adjustment Build-in rewinder mode Cut mode Loading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards Test Print 3517 $5&2 Printer’s power OFF then back to on and check that the LCD Sample of the bar code test print label Operation Panel On Line Mode Operation Reset Dump Mode Print Head/Platen/ Sensors MaintenanceCleaning Covers and Panels Optional Cutter Module Care/Handling of the Media and Ribbon Error Messages TroubleshootingError Messages Problems/Causes Solutions Restart key Possible Problems Causes Solutions Possible ProblemsError Messages Problems/Cause Solutions Do not use any tool that may damage the Print Head Removing Jammed Media Threshold setting procedure Threshold Setting Model Appendix 1 SpecificationsA1.1 Printer A1.3 Media A1.2 OptionsA1.3.1 Media Type Label Label A1.3.2 Detection Area of the Transmissive Sensor Tag paper with square holes A1.3.3 Detection Area of the Reflective SensorA1.3.4 Effective Print Area Figure below shows the effective print area on the media A1.4 Ribbon Appendix 2 Messages and Leds Symbols in the message 67$9$ „Interface Cables Appendix 3 Interface Appendix 4 Print Samples JAN13, EAN13 Interleaved 2 CODE39 StandardEAN13+2 digits EAN13+5 digits Industrial 2 UPC-A+5 digits Bar code Glossaries USB Universal Serial Bus Print head element Index Index Page Page EO1-33036B