67$9$ | Toshiba BSX5TTS25QMR, BSX5TTS22QMR, B-SX5T SERIES manual

APPENDIX 2 MESSAGES AND LEDS

ENGLISH VERSION EO1-33036

APPENDIX 2 MESSAGES AND LEDS

NOTES:7*

∙ If a command error is found in the command received, 16 bytes of the command error, starting from the command code, will be displayed. (However, [LF] and [NUL] will not be displayed.)

Example 1

[ESC] T20 G30 [LF] [NUL]

Command error

The following message appears.

%6;;5%6;77 99$$

Example 2

[ESC] XR; 0200, 0300, 0450, 1200, 1, [LF] [NUL] Command error

The following3& message appears.

%6;7$9$

Example

[ESC] PC001; 0A00, 0300, 2, 2, A, 00, B [LF] [NUL] Command error

The following message appears.

∙When the error command is shown, “? (3FH)” appears for codes other than codes 20H to 7FH and A0H to DFH.

EA2- 2

Image 45

Toshiba BSX5TTS25QMR, BSX5TTS22QMR, B-SX5T SERIES owner manual 67$9$

Contents

SX5T Series Vorsicht CE Compliance for EU only Wkhsoxj Request Regarding Maintenance Precautions Table of Contents EA2-1 EA1-1EA3-1 EA4-1 Introduction Features Product OverviewUnpacking Accessories Appearance DimensionsFront View Rear View Interior Operation Panel Precautions Printer Setup Procedure before Operation Gori Connecting the Cables to Your Printer Connecting the Power Cord Turning the Printer Turning on the PrinterTurning OFF the Printer Parts, be sure to load Loading the Media Do not over-tighten the Locking Ring of the Supply Holder Setting the Black Mark Sensor position Setting the Feed Gap Sensor position Batch mode Strip modeSTANDARD/PEEL OFF position Adjustment Build-in rewinder mode Cut mode Loading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards Test Print 3517 $5&2 Printer’s power OFF then back to on and check that the LCD Sample of the bar code test print label Operation Panel On Line Mode Operation Reset Dump Mode Maintenance CleaningPrint Head/Platen/ Sensors Covers and Panels Optional Cutter Module Care/Handling of the Media and Ribbon Error Messages TroubleshootingError Messages Problems/Causes Solutions Restart key Possible Problems Error Messages Problems/Cause SolutionsPossible Problems Causes Solutions Do not use any tool that may damage the Print Head Removing Jammed Media Threshold setting procedure Threshold Setting Appendix 1 Specifications A1.1 PrinterModel A1.3 Media A1.2 OptionsA1.3.1 Media Type Label Label A1.3.2 Detection Area of the Transmissive Sensor A1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaTag paper with square holes Figure below shows the effective print area on the media A1.4 Ribbon Appendix 2 Messages and Leds Symbols in the message 67$9$ „Interface Cables Appendix 3 Interface Appendix 4 Print Samples JAN13, EAN13 Interleaved 2 CODE39 StandardEAN13+2 digits EAN13+5 digits Industrial 2 UPC-A+5 digits Bar code Glossaries USB Universal Serial Bus Print head element Index Index Page Page EO1-33036B