Cut mode | Toshiba BSX5TTS25QMR, BSX5TTS22QMR, B-SX5T SERIES

2. PRINTER SETUP

ENGLISH VERSION EO1-33036

2.7 Loading the Media

2.7Loading the Media (Cont.)

WARNING!

The cutter is sharp, so care must be taken not to injure yourself when handling the cutter.

CAUTION!

1.Be sure to cut the backing paper of the label. Cutting labels will cause the glue to stick to the cutter which may affect the cutter quality and shorten the cutter life.

2.Use of tag paper when the thickness exceeds the specified value may affect the cutter life.

Cut mode

When the optional Cutter Module is fitted, the media is automatically cut. A swing cutter and a rotary cutter are available as an option, but they are used in the same way.

Insert the leading edge of the media into the Media Outlet of the Cutter Module.

Cutter Module

Media

Media Outlet

13.If the loaded media is direct thermal media (a chemically treated surface), the media loading procedure is now completed. Close the Ribbon Shaft Holder Plate, and turn the Head Lever to Lock position to close. Then, close the Top Cover.

If the media is thermal transfer media, it is also necessary to load a ribbon. Refer to Section 2.8 Loading the Ribbon.

E2-11

Image 21

Toshiba BSX5TTS25QMR, BSX5TTS22QMR, B-SX5T SERIES owner manual Cut mode

Contents

SX5T Series Vorsicht CE Compliance for EU only Wkhsoxj Request Regarding Maintenance Precautions Table of Contents EA2-1 EA1-1EA3-1 EA4-1 Introduction Features Product OverviewUnpacking Accessories Appearance DimensionsFront View Rear View Interior Operation Panel Precautions Printer Setup Procedure before Operation Gori Connecting the Cables to Your Printer Connecting the Power Cord Turning the Printer Turning on the PrinterTurning OFF the Printer Parts, be sure to load Loading the Media Do not over-tighten the Locking Ring of the Supply Holder Setting the Black Mark Sensor position Setting the Feed Gap Sensor position Batch mode Strip modeSTANDARD/PEEL OFF position Adjustment Build-in rewinder mode Cut mode Loading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards Test Print 3517 $5&2 Printer’s power OFF then back to on and check that the LCD Sample of the bar code test print label Operation Panel On Line Mode Operation Reset Dump Mode Maintenance CleaningPrint Head/Platen/ Sensors Covers and Panels Optional Cutter Module Care/Handling of the Media and Ribbon Error Messages TroubleshootingError Messages Problems/Causes Solutions Restart key Possible Problems Error Messages Problems/Cause SolutionsPossible Problems Causes Solutions Do not use any tool that may damage the Print Head Removing Jammed Media Threshold setting procedure Threshold Setting Appendix 1 Specifications A1.1 PrinterModel A1.3 Media A1.2 OptionsA1.3.1 Media Type Label Label A1.3.2 Detection Area of the Transmissive Sensor A1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaTag paper with square holes Figure below shows the effective print area on the media A1.4 Ribbon Appendix 2 Messages and Leds Symbols in the message 67$9$ „Interface Cables Appendix 3 Interface Appendix 4 Print Samples JAN13, EAN13 Interleaved 2 CODE39 StandardEAN13+2 digits EAN13+5 digits Industrial 2 UPC-A+5 digits Bar code Glossaries USB Universal Serial Bus Print head element Index Index Page Page EO1-33036B