2. PRINTER SETUP | ENGLISH VERSION |
2.10 Test Print
2.10 Test Print
NOTES:
1.Select the sensor type which matches the media being used. Basically, the Reflective Sensor (Black Mark Sensor) is for tag paper, and the Transmissive Sensor (Feed Gap Sensor) is for labels.
2.Select the print mode which matches the media being used. Basically, the thermal transfer is with ribbon, and the thermal direct is without ribbon.
A print test should be performed to check that the printer is operating correctly.
The following paragraphs guide you through the diagnostic procedure for test label printing. Please follow the
| following!',$*message. $ | |||
best results. |
|
|
| |
1. | Use label stock for the test print. For best results, use labels that are | |||
| 76 mm or longer in length. | |||
2. | Press and hold the [FEED] and [PAUSE] keys while turning on the | |||
| printer power switch. The LCD Message Display will show the | |||
3. | appear!7(67. | 3517 |
| |
Press the | [FEED] key three times to advance to the test print mode as | |||
| 35,17&21',7,21 |
| ||
| indicated!7(67by | 35,17the following message in the LCD Message Display. | ||
4. | !76735,17 |
| ||
Press the | [PAUSE] key and the print condition setting display will | |||
5. | ,668( | &2817 | ||
Press the | [PAUSE] | key and the issue count setting display will | ||
| 35,1763(('¥V | |||
| appear. Set the issue count with the [FEED] or [RESTART] key. | |||
6. | Press the | [PAUSE] key and the print speed setting display will | ||
| appear.!7(67Set the35,17print speed with the [FEED] or [RESTART] key. | |||
7. Press the [PAUSE] key and the sensor type setting display will appear6(16257!7(6735,17!7(673,7. Select5$the16sensor type with the [FEED] or [RESTART] key.
8. Press3577<3(the [PAUSE]75$16)5key and the print mode setting display will appear. Select the print mode with the [FEED] or [RESTART] key.
