GENERAL PRECAUTIONS REGARDING THE SERVICE FOR e-STUDIO281c/351c/451c

The installation and service should be done by a qualified service

technician.

1) Transportation/Installation
- When transporting/installing the equipment, employ four persons and be sure to hold the posi-
tions as shown in the figure.
The equipment is quite heavy and weighs approximately 113 kg (249 lb), therefore pay full atten-
tion when handling it.
- Be sure not to hold the movable parts or units (e.g. the control panel, ADU or RADF) when trans-
porting the equipment.
- Be sure to use a dedicated outlet with AC 110 V / 13.2 A, 115 V or 127 V / 12 A, 220-240 V or 240
V / 8 A for its power source.
- The equipment must be grounded for safety.
- Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and
direct sunlight.
- Provide proper ventilation since the equipment emits a slight amount of ozone.
- To insure adequate working space for the copying operation, keep a minimum clearance of 80
cm (32”) on the left, 80 cm (32”) on the right and 10 cm (4”) on the rear.
- The equipment shall be installed near the socket outlet and shall be accessible.
- Be sure to fix and plug in the power cable securely after the installation so that no one trips over
it.