Toshiba e-STUDIO281c, e-STUDIO351c, e-STUDIO451c

e-STUDIO281c/351c/451c TROUBLESHOOTING June 2005 © TOSHIBA TEC

5 - 40

[EAC0] Transport delay jam

MJ-1024

Is there any paper remaining on the transport path in the finisher, saddle stitcher section or

equipment?

ÈYES ÆRemove the paper.

Is the connector J708 on the finisher controller PC board disconnected?

Is the harness connecting the finisher controller PC board and inlet sensor (PI33) open cir-

cuited?

ÈYES ÆConnect the connector securely. Replace the harness.

Is the inlet sensor working properly? (Check the movement of the actuator.)

NO Æ1) Connect the connector of the sensor securely.

2) Attach the actuator securely if its shaft is out of place.

3) Replace the sensor.

YES

Replace the finisher controller PC board.