June 2005 © TOSHIBA TEC e-STUDIO281c/351c/451c FIRMWARE UPDATING
6 - 3
6
PWA-DWNLD-350-JIG2 (48MB)
Fig.6-1 Jig board: PWA-DWNLD-350-JIG2 (48 MB)
Important:
• To perform update, two download jigs (PWA-DWNLD-350-JIG2) are needed.
• The download jig (PWA-DWNLD-350-JIG) is the jig in which the Flash ROM is mounted on
the board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write the
data to these Flash ROMs. Refer to the following to write the data.
P.6-13 "6.1.2 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
K-PWA-DLM-320
Fig.6-2 Jig board: K-PWA-DLM-320
Important:
Pay attention to the direction of the ROM.
ROM4
ROM5
ROM6
ROM1
ROM2
ROM3
Connector
(for SYS board
connection)
Connector
(for ROM writer
adapter connection)
Connector Mark for ROM
installation direction
ROM
LED