Toshiba e-STUDIO281c, e-STUDIO351c, e-STUDIO451c [MJ-1023][ MJ-1024]

e-STUDIO281c/351c/451c FIRMWARE UPDATING June 2005 © TOSHIBA TEC

6 - 20

Finisher firmware (MJ-1023/1024) and saddle stitcher firmware (MJ-1024 only) are written on the fin-

isher ROM. These two kinds of firmware can be updated individually by installing the download jig to

the finisher control PC board.

Remark:

The following updates are needed according to the finisher model.

• MJ-1023 (Console type):

Only the update of “Finisher firmware” is needed.

• MJ-1024 (Console type with the saddle stitcher):

Two kinds of update “Finisher firmware” and “Saddle stitcher firmware” are needed.

(1) Install the ROM to the download jig.

Make sure the direction is correct ( P.6-3 " K-PWA-DLM-320").

(2) Shut down the equipment.

(3) Take off the finisher rear cover.

Fig.6-16

* Connect the finisher interface cable with the equipment after removing the finisher rear cover.

Finisher rear cover Finisher rear cover

[MJ-1023][MJ-1024]